Welcome to the PHCC Wiki.

Please create an user account and then help us to make this the one-stop for information on PHCC.

 Actions

Difference between revisions of "Troubleshooting"

From PHCC

 
(2 intermediate revisions by the same user not shown)
Line 1: Line 1:
'''Mainboard:'''
 
  
I. Analog inputs are "jittering":
+
== Mainboard: ==
 +
 
 +
 
 +
'''I. Analog inputs are "jittering":'''
  
 
Sometimes analog inputs are jittering all the time without any reason.
 
Sometimes analog inputs are jittering all the time without any reason.
  
Help:  
+
 
 +
''Help:''
  
 
Use jumper / bridges on every analog input, which isn't in use.
 
Use jumper / bridges on every analog input, which isn't in use.
Line 12: Line 15:
  
  
""Key64-Daughterboard:""
+
== Key64-Daughterboard: ==
  
II. Ghost-effect of inputs:  
+
 
 +
'''II. Ghost-effect of inputs:'''
  
 
If you have connected only one switch (e.g. toggle, rotary, momentary, etc.) to  
 
If you have connected only one switch (e.g. toggle, rotary, momentary, etc.) to  
Line 26: Line 30:
 
Ghosting will show closed electrical circuits - even if they aren't existent or not closed.  
 
Ghosting will show closed electrical circuits - even if they aren't existent or not closed.  
  
Help:  
+
 
 +
''Help:''
  
 
1. Check the soldering points on your Motherboard.
 
1. Check the soldering points on your Motherboard.

Latest revision as of 19:19, 21 November 2021

Mainboard:

I. Analog inputs are "jittering":

Sometimes analog inputs are jittering all the time without any reason.


Help:

Use jumper / bridges on every analog input, which isn't in use.

Put the jumper on every pin#1 & pin#2.


Key64-Daughterboard:

II. Ghost-effect of inputs:

If you have connected only one switch (e.g. toggle, rotary, momentary, etc.) to

your Key64-Daughterboard, and you use it (e.g. turn it to ON),

and there are more connections showing as ON, this would be called Ghost-effect.

It can also happen if there are more switches than only one attached .

Ghosting will show closed electrical circuits - even if they aren't existent or not closed.


Help:

1. Check the soldering points on your Motherboard.

Sometimes two soldering points are connected by accident.

2. Check your flatcables from Motherboard to Key64-Daughterboard.

Sometimes there are two or more wires connected by accident.

Often happens if the connector isn't is attached 100% correctly.

3. Check your flatcables at Key64-Daughterboard.

Sometimes there are two or more wires connected by accident.

Often happens if the connector isn't is attached 100% correctly.

4. Check your common and other connections at Key64-Daughterboard.

Crosscheck with the wiring diagram on this page.

Are the common pins attached to the correct corresponding connection-pins?

Are your connection pins all attached correctly?